Backwall Design Guidelines For Shelves

1414 Words3 Pages

These ‘Backwall Design Guidelines’ is for shelves designed for perfumery of the SENSAI brand. Unlike ‘Counter Design Guidelines’, these shelves are for stores the products are displayed on the shelves.

There are two typical designs by the space given.

1. Basic type: Narrow type (width: from 600 to 2000 mm)

2. Wide type: Wide type (width: from 1800 to 2700 mm)

Each of these types will further be divided into three different types of specs by the condition, then will compose of a total of six types.

Spec-A: The most recommended backwall consists of the illuminated Kanebo International signage, graphic area (light box), the illuminated SENSAI signage and shelves with lighting.

Spec-B: In case graphics cannot be installed, and this shelf consists of the non-illuminated Kanebo International signage, the non-illuminated SENSAI signage and shelves with lighting.

Option: Although strongly not recommended, the backwall with no electrical power is provided.

Apply this ‘Guideline’ when a partial modification is possible such as; shelf board, light box and signage.

03

How to use this ‘Guidelines’

1. Select either the basic type or wide type.

Check the width of the provided space.

When the width is 2000 mm or narrower, the basic type is appropriate and when it is 2000 mm or wider, the wide type is appropriate. When the width is from 1800 mm to 2000 mm, you can select either of the types according to the site condition. The reference shelves are 1800 mm high, 2100 mm high and 2300 mm high. Select a shelf the most appropriate to the site environment and adjust the shelf to fit to the site.

2. Select either spec-A or spec-B. The recommended type is always spec-A.

Select option when electrical source is not available.

Y...

... middle of paper ...

...n the list on page 5, adjust the height and width according to the drawing below.

60,71,80 Storage & base boardに書く内容

Select either storage type according to the conditions of your store.

42,79 Shelf boardのページに書く内容

Details of the shelf and rules for the lighting equipment under the shelf boards. Determine the specifications according to the site conditions as shown the drawings below.

82 Podiumのページに書く内容

This podium can be used only for perfumery.

The dimension of the podium ranges from 450 mm to 1100 mm at maximum.

Except in the case where the dimension of the backwall is 900 mm or narrower, the podium must not exceed half of the width of the backwall. The dimension of the backwall is 900 mm or narrower, install a podium with width of 450 mm.

Specify the width of podium most appreciate for each site.

Cover with a cushion to cut off lighting filtered

More about Backwall Design Guidelines For Shelves

Open Document