2.4. Rectangular patch antenna Microstrip antenna is also called as a patch antenna. Microstrip patch antenna contains of a two sides. One side is a radiating patch of a dielectric substrate and the other side is the ground plane side as shown in Fig 2.2. Generally, patch antenna consists of materials that have good conducting properties such as Gold and Copper and it can be made any possible shape. Figure 2.2: The simple design of rectangular patch antenna However, in order to simplify analysis
Performance Analysis of an Aperture Coupled Microstrip Stacked Patch Antenna For WLAN Applications Abstarct- In this paper microstrip stacked patch antenna with 10mm air gap using aperture coupling technique at frequency of 5.8 GHz has been discussed. Microstrip antennas suffer from a biggest drawback of narrow bandwidth and this can be improved by a technique called aperture coupling and further by stacking of antennas without increase in surface area of antenna. Without stacking bandwidth
model were compared experimentally by using vector network analyzer to those obtained from simulations using the simulation software. Now I feel strongly to carry out my research work more efficiently in a group, require an exposure, and a nice microstrip antenna fabrication and characterization facility. I got excited looking at the research areas, faculty and lab at the Ohio state university, the research experience I have gained and the techniques and skills I have learned so far will be of immense
Prerana Chowdary Yerneni Review paper summary: The main objective of this paper was to design a triple band equal split power divider circuit. Introduction: With the advancement in technologies, concentrating on transceivers is increasing. Transceivers operate at various frequencies. The author uses Wilkinson power divider (using three section transmission line transformer) which operates at three different arbitrary frequencies simultaneously to generate the required specifications. This condition
Radio frequency energy is the energy transmitted by sources that can generate electromagnetic fields like TV signals, radio signal, wireless networks and cell phone towers, by using specially designed circuits connected to a an antenna this electromagnetic energy can be harvested and converted into a usable DC voltage. One of the applications of this technology is in radio frequency identification tags in which harvesting device can receives an RF signal from a sensing device; this RF signal can
3.1 Low Pass Filter A low pass filter is a filter that passes low-frequency signals but attenuates frequencies higher than the cutoff frequency we can say that low pass filter has only single cutoff frequency and one pass band.It is sometimes called a high-cut filter, or treble cut filter when used in audio applications. A low-pass filter is the opposite of a high-pass filter, and a band-pass filter is a combination of a low-pass and a high-pass filter. In low pass filter Inductors block high-frequency
INTRODUCTION Throughout the history of civilizations man tried to establish his own way to express himself and represent his ideas to others. These ways, which are defined as languages, supported the ability to communicate, providing one of the most essential instincts needed by mankind. For not over than few tens of meters, man’s sheer voice formed the first and simplest humanist wireless communication scheme, where the frequencies produced from the man's throat vibrates the surrounding air molecules
My schooling and three and a half years of undergraduate studies in ECE at the JNTUH university have made the choice of further study, for me, an obvious one. This should be attributed in part to the values that have been inculcated in me during my formative years in an educated middle class family background. My goal in academics is to pursue knowledge to be part of a pioneering research field and contribute significantly to the development of human society. My goal in my life is to have some patents
Global-navigation Satellite Systems (GNSS) provide navigational data to airborne transportations and various other applications. Mainly two satellite constellations are in use today for navigational purposes. They are global positioning system (GPS) which is provided by the United States and global navigation satellite systems (GLONASS) which is provided by the Russian federation [1]. GPS and GLONASS satellites fly in medium Earth orbit (MEO) at an altitude of approximately 20,200 km and 19,100 km
Abstarct: In this paper we get an overview of the dielectric resonator antenna which replaced the simple form of antennas that were being used for the past ten years. These dielectric antenna have been of a great importance to the research work in antenna field as these have a great dielectric constant and higher Q factor than the other isotropic or directive antennas. Earlier these antennas were considered to be energy storage devices but in this paper we have made use of the DRA antennas as radiators