Dealing with Energized Line in the Power Line Field

1409 Words3 Pages

Do you feel like having power is easy as turning on a light switch to to plugging an appliance into the wall maybe you do but after reading this your opinion might change.This research paper will discuss the idea of barehanding and how to work on energized power lines. There is one certain technique that is called barehanding . “Barehanding” is a safe way for trained transmission linemen to work on high-voltage power lines, while being attached to a fully energized conductor (tower or helicopter). This technique is used to perform required maintenance such as replacing insulators, connecting hardware, and conductors on the transmission lines. It isn't very common but the idea of barehanding is growing. Barehanding can be dangerous because there is hazardous voltage and when electricity goes into your body, it has to come out somewhere. To prevent contact between the worker and energized p, you must practice safety through the use of equipment. First, while barehanding there is a suit that consist of wearing a protective wear while the wire is energized the suit is made up of specialized boots, protective socks with interwoven microscopic stainless steel fibers, in addition to a hard hat. The $1,300 suit comes with boots that have a conductive sole, a jumper, a hooded shirt, gloves, and socks.. Linemen wear flame-retardant clothing which includes hooded sweatshirts, long-sleeved shirts, pants, winter clothing, and overalls. One well-known distributor that makes this clothing is Carhart. Also, lineman are required to wear safety glasses, steel-toed boots, leather gloves and proper safety gear. The proper safety gear can include equipment such as flame-retardant harnesses. On a daily basis the linemen inspect all of their perso... ... middle of paper ... ... is rotten, there is a certain procedure you can follow. First you can always butt test the pole. This consists of you taking your hammer and hitting the pole. If hitting the pole makes a particular sound, then the pole is rotten. Another method is done by drilling a hole into the pole at ground level and by doing that you will be able to tell if the pole is rotten. If it is, obviously you'll have to replace the pole, but if it’s not rotten you should plug the hole you just drilled. If you do not plug the hole it can lead to future problems. This research paper consisted of the idea of barehanding and how to work on energized power lines. It also informs you of all the things you need to be aware of. But most importantly how to stay safe on the job. Now since you read this, next time you turn on a light switch just think about all that happens when you do so.

More about Dealing with Energized Line in the Power Line Field

Open Document